The HTR121 Heat Tint Removal Machine with Brush Attachment quickly and economically removes heat tint and discoloration from welded hear-affected zones on stainless steel after TIG/MIG welding applications. A light application of Dynaflux HTR-120 Solution using brush applicator gets into smaller places and eliminates time consuming grinding, sanding, buffing and polishing. Cleans areas faster while it pickles and passivates in one easy step. Accessories and solution sold separately. Can be used with your current HTR 121 Machine at LOW power setting.

Voltage (AC)
115 V

Complete Machine with Brush Applicator with 2 replacement brushes

Connect unit to 110 volt power. Secure ground clip to work piece. Saturate applicator boot or applicator pad with HTR-120 Solution. Allow excess fluid to drip off applicator. Turn unit ON. Pass applicator GENTLY over the heat-stained weld zone. Allow applicator boot or applicator pad to float over the fluid layer. The chemical action of the electrically charged solution barrier removes the heat stain. NOTE: Any excessive pressure that effectively squeezes the solution away and permits dry grounding to occur is counterproductive and shortens the life of the applicator boot or pad. Dry grounding or arcing of applicator wand may trip relay. Push to reset. Rinse with clean water immediately after cleaning to neutralize any chemical left on surface. This will prevent white oxidation from forming on the surface.

If white oxidation does appear, residual film remaining on the work surface may be removed using Dynaflux Stainless Steel Finisherâ„¢ (Product No. 394) .